Yzf R125 Ignition Fault 33

Discussion in 'Technical Discussions' started by pault69, Jul 18, 2013.


  1. 2011 model flashing 3 and 3 on management light. Bike had run fine parked up for 2 weeks whilst on hols,

    Pump wasn't priming and was stuck so removed and sorted pump which now primes when ignition turned on ok

    Coil swapped as my research shows the fault to be primary ignition side

    Wonderd if this could be one of the other sensors such as side stand etc which disables the ignition circuit.

    Bike cranks over so no fault on starter circuit

    Any thoughts ?
     

  2. Did you fix this I’m having similar issue . My bike starts and runs then after few mins it cuts out displaying error code 33 but will start straight back up then start getting up to speed and cuts out again and again . Can’t figure out what it is
     
RELATED TOPICS:

Share This Page